Heat Resistant Board Adhesive 310ml for Stoves and Fireplaces
Ready mixed high temperature adhesive for use with insulation boards, vermiculite boards, high temperature plasterboards and construction boards. Primarily for the joints between boards. The material can be used to fix boards to brickwork, blockwork etc as long as the wall is flat and the gap does not exceed 5mm otherwise Vitcas HB60 can be used. Heat resistant to 1350oC
Surfaces to be joined must be clean, dry and free of dust.
The faces of construction board should be wetted before application.
The material should be applied onto the surface of the boards or the edge of the boards with a 6mm tile comb to give a 3mm bed.
The product is air setting and the setting time is affected by the bed thickness and the ambient temperature. At 20oC, at least 12 hours should be allowed for setting.
When the material is dry it can be sanded if required.
Storage and Shelf Life: Store in a cool dry place between 5oC and 25oC. After use make sure that the lid is replaced properly. Under these conditions the shelf life should be a minimum of 12 months.
The information given is based on our experience and reports from customers. There are many factors outside our control and knowledge, especially the method and conditions of application which affect the use and performance of our products and for which reason no warranty is given, express or implied. Users should make their own tests to determine the applicability of such information or the suitability of any products for their own particular purposes. The product should be used, as described in our instructions. This information does not replace professional training and does not replace the necessity to comply with health and safety regulations.
Coverage: A guide to the amount of the material contained in one 310ml cartridge
Bead dia. 4mm – length approx. 18 metres
Bead dia. 6mm – length approx. 8 metres
Bead dia. 8mm – length approx. 5 metres
Bead dia. 10mm – length approx. 3 metres
You might also like